This is the bottom view of my layout tray and gives an overview of all underside wiring done so far. The available working space is only 0.47" high. In other words, any item installed underneath is limited in height. A Turtle drive for my turnouts anywhere on this side is absolutely  out of the question! Maybe Memory Wire installation will do. Future additional wiring will be the “Occupied Track Detection” of the Shadow Station and the “Reverse Loop Section”, which may be finished by year’s end. The Shadow Station tracks and the Reverse Loop Connection track are on the “0 mm level” and will be out of sight. Therefore an “Occupied Track Detection” of the Shadow Station is a must and may not be finished by year’s end. It will require additional wiring. The covered area will be accessible for maintenance by means of removable top sections. The following photos will be close ups of the Barrier Strips, its wiring and cable dressing.

Wednesday, 19 March 2008

1650

0

80.17 KB (800 x 500 px)

Dalman_Ed

1,300.04 KB (2832 x 1772 px)